Win10 OpenVPN Proxy設定

哈囉!各位大家好~

目前本人是用win10的系統
大部分的時間呢是使用公司的網絡
但是電腦要連上公司的網絡必須經過Proxy
才能夠使用網絡的
不知道OpenVPN該如何設定 ?
因為打開來直接連好像連不上...

麻煩各位教學了🥺🥺🥺

已邀请:

Lucifer 【新手级】

OpenVPN支援http proxy的說明和指令如下,供您參考:


OpenVPN supports connections through an HTTP proxy, with the following authentication modes:

  • No proxy authentication
  • Basic proxy authentication
  • NTLM proxy authentication

First of all, HTTP proxy usage requires that you use TCP as the tunnel carrier protocol. So add the following to both client and server configurations:

proto tcp

Make sure that any proto udp lines in the config files are deleted.

Next, add the http-proxy directive to the client configuration file.

For example, suppose you have an HTTP proxy server on the client LAN at 192.168.4.1, which is listening for connections on port 1080. Add this to the client config:

http-proxy 192.168.4.1 1080

Suppose the HTTP proxy requires Basic authentication:

http-proxy 192.168.4.1 1080 stdin basic

Suppose the HTTP proxy requires NTLM authentication:

http-proxy 192.168.4.1 1080 stdin ntlm

The two authentication examples above will cause OpenVPN to prompt for a username/password from standard input. If you would instead like to place these credentials in a file, replace stdin with a filename, and place the username on line 1 of this file and the password on line 2.

Lucifer 【新手级】

由以上說明,似乎只能支援TCP模式。但現在NordVPN 只釋放UDP伺服器資料,您仍可試試以TCP連線那些伺服器,不考慮牆的因素下,通常應該也可以。

zsxfbj 【新手级】

用apache做个代理服务器,udp、tcp都无所谓了

要回复问题请先登录注册